Sheep husbandry - Castrating lambs with rubber rings

Sheep husbandry - Castrating lambs with rubber rings - Hallo friendsDesigning a large farm, In the article you read this time with the title Sheep husbandry - Castrating lambs with rubber rings, We have prepared this article for you to read and retrieve information therein. Hopefully the contents of postings Article breeding methods, Article castration, Article male lambs with rubber rings, Article NZ Sheep, Article practical advice, Article sheep husbandry, We write this you can understand. Alright, good read.

Title : Sheep husbandry - Castrating lambs with rubber rings
link : Sheep husbandry - Castrating lambs with rubber rings

Read too


Sheep husbandry - Castrating lambs with rubber rings

By Dr Clive Dalton

Castrating lambs with rubber rings

Using rubber rings is the best way to castrate lambs in both large and small flocks. It is bloodless and research has shown that the intense pain only lasts a short time. Lambs should be castrated using rings before they are 6 weeks old - the younger the better.

The main concern is to make sure the ring is placed in the correct position, so the ram will become a proper wether.

If the testicles are missed, then the lamb will be a 'cryptorchid' where one or both testicles can be felt under the skin along the belly, or squeezed back up into the body cavity. These sheep are usually infertile, but there is always the risk of an odd animal being an effective ram.

Cryptorchids grow faster than wethers due to the testosterone produced by the testicles.

Objective
The procedure must be done so that the scrotum, along with both testicles, is captured when the ring is released. The ring must be above scrotum and testicles, and below the rudimentary teats.

Method

1. Get an assistant to catch the lamb and sit it on its rear end on a board or rail at standing height.



2. Grab the end of the scrotum and pull it through the open ring.



3. With the ring fully open and resting on the lamb's body, use your fingers and thumb to locate the testicles and press down to squeeze them through the ring. Hold them there and release the ring.


4. Before flicking the pliers off the ring, make sure there are two testicles now in the scrotum.


5. Double check - testicles in - teats out!


Thus Article Sheep husbandry - Castrating lambs with rubber rings

That's an article Sheep husbandry - Castrating lambs with rubber rings This time, hopefully can give benefits to all of you. well, see you in posting other articles.

You are now reading the article Sheep husbandry - Castrating lambs with rubber rings with the link address https://designfarms.blogspot.com/2011/10/sheep-husbandry-castrating-lambs-with.html

Subscribe to receive free email updates:

0 Response to "Sheep husbandry - Castrating lambs with rubber rings"

Post a Comment